Quintum Technologies Tenor AS Quick Start - Manual (Page 4)

STEP 6: Connect to Ethernet Hub/Switch (LAN)
You can use these instructions for general connection purposes only. The Ethernet hub/switch manufacturer’s docu-
mentation should provide specific instructions for connection to another device, such as the Tenor AS.
Figure 4: Connect to Ethernet Hub/Switch
STEP 7: Configuration
You are able to configure the unit through the Tenor Configuration Manager (for more information see the Tenor Con-
figuration Manager/Tenor Monitor User’s Guide) or through the Command Line Interface (CLI) (see the Command
Line Interface User’s Guide). Both guides are available on the CD ROM you received with the unit.
1. Plug one end of the RJ-45 ethernet cable
into the port labeled LAN.
2. Plug the other end of the cable into one of
the Ethernet hub/switch ports.
Data
Network
Ethernet Hub/Switch
71 James Way
Eatontown, New Jersey 07724
1.732.460.9000
1.732.544.9119 (fax) Technical Support:
Toll Free (U.S. Only): 1.877.435.7553
Internationally: 1.732.460.9399
Email:[email protected]