Quintum Technologies Tenor DX Quick Start - Manual (Page 3)

16. To set the Default Gateway IP, type change 1 g followed by the IP address for the default gateway IP.
17. Type submit.
18. Type maint to reach the maintenance mode and then mc. Type reset. A confirmation message will ask if you
want to reset the unit. Type yes to reset the unit. The reboot enables the Tenor to incorporate the new settings.
19. Once the IP information is set, you are ready to configure the unit. See the Tenor DX User’s Guide (included on your CD
ROM) for details.
STEP 5: Connect the Unit
NOTE: If a T1/E1 card is installed in a port, and the the card is set to offline (via Command Line Interface), the LED
on each side of the port will flash yellow.
The following steps are required to fully connect the Tenor DX.
• Connect to Trunk Interface (PSTN)
• Connect to Line Interface (PBX)
• Connect to Ethernet Hub/Switch
Adjacent port pairs (i.e., 1/2, 3/4, etc.) are configured by default to connect to each other (power off bypass) when the
unit is turned off, or when the unit is in Offline mode. This is the preferred method when connecting one of the lines
to a PBX, and its adjacent pair to the PSTN. However, if you have adjacent port pairs that are connected to similar
devices (i.e., both going to PSTN) in which you do not want the two ports to be connected to each other in case of
power off or offline, you should set the power off bypass = 0. Each pair of ports (1/2, 3/4, 5/6 and 7/8) have their own
online/offline and power off bypass control. See the Configuration Manager online help or the Command Line Inter-
face (CLI) guide for specific configuration information.
Connect to Trunk Interface (PSTN)
Figure 4:
1 2 3 4 5 6 7 8 R E S E T
D I A G
CONSOLE POWER
ALERT
LAN 1 LAN 2 Line/Act
100
Line/Act
100
PSTN
Patch Panel
RJ-45
1. Plug one end of the straight through RJ-45 cable into one of the
eight network ports on the front of the unit. The cable from
Quintum is the green RJ-45 cable.
2. Connect the other end of the RJ-45 straight cable to the patch
panel which houses your telephone lines.
NOTE: Connecting to the patch panel may require
trained telephone personnel.
Connect to Trunk Line (PSTN)