Marantz SA8005 - Manual (Page 57)

57
Appendix Tips Playback Connections Contents
Front panel Display Rear panel Index Remote
Settings
Switching the function of the volume buttons on the remote control
When the function of the VOLUME df buttons on the remote control is
set to “Variable”, the analog audio output level can be adjusted.
AMP (Default) : Adjusts the volume of Marantz amplifiers.
Variable : Adjusts the analog audio output level of the analog audio signal
output from this unit.
%
• Check the operation of this unit and connected devices after setting the function of
the VOLUME df buttons on the remote control.
Set the function of the volume buttons
on the remote control to “Variable”
1 Press and hold the ENTER and number 1 button down
together for more than 5 seconds.
The remote mode selection button (REMOTE MODE CD) lights for
approximately 1 second.
NOTE
• To adjust the analog audio signal output from this unit using the remote control,
also set “Audio Out” (vpage 55) to “Variable”.
Set the function of the volume buttons
on the remote control to “AMP”
1 Press and hold the ENTER and number 2 button down
together for more than 5 seconds.
The remote mode selection button (REMOTE MODE NET) lights
for approximately 1 second.
NOTE
• The remote control returns to the factory settings when the batteries are removed.
Therefore, set the remote control code again after replacing the batteries.