Formax FD 340 - Manual (Page 9)

5
MULTI-SHEET FEEDING (OPTIONAL) MULTI-SHEET FEEDING (OPTIONAL)
The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of paper of up to three 20 lb
sheets of paper.
1. Make sure that all paper is removed form the feed
table.
2. Adjust the side guides on the feeder for the proper
paper size. Loosen the brass thumb screw, open
or close the guides to fi t the paper width and
retighten the thumbscrew (Fig 8a).
3. Slide the pre-collated paper set into the multi-sheet
feeder. When feeding stapled sets the documents
should be placed with the staple on the operators
side and leading (Fig 9).
4. The sheets of paper will be automatically pulled into
the folder (there is a one second delay after the
paper is placed in the feeder).
5. If the fold is skewed, turn the skew adjustment knob
located on the back of the feeder left or right to make
corrections (Fig 8b).
6. To remove the multi-sheet feeder depress the release
levers located on either side of the lower back side of
the feeder (Fig. 10), tilt the feeder forward and lift. To
reinstall depress the levers and reinsert.
Staple
Fig. 9
Fig. 8a Fig 8b
Brass thumbscrew Skew Adjuster
Release Levers
Fig. 10