Formax FD 340 - Manual (Page 12)

OPERATOR MAINTENANCE
1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding. This allows
toner to set on the forms and static electricity to discharge. A 400 Series Paper Jogger is recommended for
best results. The Jogger squares the forms and dissipates heat and static created by laser printers.
2. Clean in-feed tires and fold rollers with Formax recommended roller cleaner & rejuvenator to remove paper
dust and toner. A Formax Cleaner Kit is available from your dealer. A damp cloth with water is the best
alternative.
CAUTION: Do not use any chemicals other than the roller cleaner & rejuvenator or water.
8
Fig. 15
Fold Rollers
1. Make sure machine is turned off and unplugged. All
folders have four (4) rubber rollers (Fig. 15).
2. Remove the upper and lower fold plates.
3. Using Formax roller cleaner, spray a new cotton cloth
until the cloth is saturated. Wipe the wet cloth in a back
and forth motion making sure to clean the entire surface
of the fold and seal rollers. Next, use a dry cloth to wipe
off excess toner. The cloth should be covered with black
toner surplus from cleaning the rollers.
4. Make sure to run 10-15 sheets of blank copy paper
to ensure all cleaner has been removed from the fold
rollers. Running blank sheets will remove any excess
residue of cleaner on the rollers.
CLEANING PROCEDURES: