Dynaudio pmn - Manual (Page 47)

45
THE AIR REMOTE
REF LEVEL 1-3 keys
To recall Reference Level 1-3:
Press relevant key shortly. The key LED indicates activated
Reference Level.
To set Reference Level 1-3:
Set level using the large VOLUME dialer in the center of
the remote. Press and hold relevant Reference level key
for approx. 2 seconds. The LED will flash 3 times and then
the new Reference level is set.
Power up state: Off (volume defined by potentiometer)
PRESET 1/3 AND 2/4 keys
These keys will recall presets 1/3 & 2/4 depending on the
position of the SHIFT key.
Power up state: Off (no presets recalled).
SHIFT key
Combined with the PRESET 1/3 AND 2/4 keys (described
above) presets 1 to 4 can be recalled.
Preset Bank 1 is presets 1and 2. Preset bank 2 is presets
3 and 4.
Power up state: Preset Bank 1 selected.
MUTE/UNMUTE - SOLO keys for the channels:
L - C - R - Ls - SUB - Rs
The key LEDs indicates the following states:
LED ON Speaker on
LED OFF Speaker Mute
LED Flashing Speaker Solo
Mute/Unmute
With a single press on these keys the monitors are
muted/unmuted.
Solo Function
Press and hold one of the keys to activate Solo function for
corresponding channel.
All other monitors can enter solo mode simultaneously.
If a key is pressed (not held) the original mute status will
be recalled.
Power up state: On
VOLUME potentiometer
If no REFERENCE LEVEL keys are activated this control
sets the Master volume on all channels in the system.
If one of the REFERENCE LEVEL keys are activated,
these will define the reference level.
When REFERENCE LEVEL keys are deactivated Master
volume returns to the level defined by the position of the
VOLUME potentiometer.
Power up state: Potentiometer setting defines
volume level.
Potentiometer LED function:
As soon as the volume level is defined by the
potentiometer setting, the LED is on. LED goes off when
volume is set by other devices than the remote unit.
Power up state: LED on (Potentiometer setting defines
volume level).
Air_US_rev_111.qxd 16-12-2004 14:18 Page 45