Denon 1083 - Manual (Page 36)

36
Preset memory
DVD 1
4
2, 3
1
2, 3
1
2
3
Press the power ON/SOURCE button and the OFF button at
the same time.
• “PRE” appears on the remote control unit’s display.
The “SEL” indicator flashes and the device selection mode is
set.
Use the • and ª cursor buttons to display the mode you want
to preset, then press the ENTER button.
The display switches as shown below each time the • and
ª
cursor buttons are pressed.
Use the • and ª cursor buttons to display “PRE” on the
remote control unit, then press the ENTER button.
The remote control unit’s display switches as follows each
time the • and ª cursor buttons are pressed.
4
5
6
“OK” is displayed when the signals are registered and the
mode is terminated.
Referring to the included List of
Preset Codes, use the number
buttons to input the preset code (a
4-digit number) for the
manufacturer of the component
whose signals you want to store in
the memory.
To store the codes of another component in the memory,
repeat steps 1 to 5.
The preset codes are as follows upon shipment from the factory and after resetting:
TV, VCR1 ......................................................................HITACHI
CD, MD, TAPE, CDR, VDP, DVD..................................DENON
VCR2, DBS...................................................................SONY
CABLE..........................................................................ABC
NOTES:
• Depending on the model and year of manufacture, this function cannot be used for some models, even if the your device is listed on the
included list of preset codes.
• Some manufacturers use more than one type of remote control code. Refer to the included list of preset codes to change the number and
check it out.
• For the CDR/MD, DBS/CABLE, VCR-1/VCR-2 and DVD/VDP modes, the unused mode can be deleted.
To delete an unused mode, select the mode to be deleted when registering the preset memory, input preset number “9999”, then press the
ENTER button.
For example, when the MD mode is deleted, only the CDR mode is displayed when the CDR/MD button is pressed.
This setting can be canceled by resetting the preset memory or registering another preset signal.
The included remote control unit can be used to operate devices of different brands by registering the preset number corresponding to the brand
of your device.
For some models the remote control unit or the device may not operate properly. In this case, use the learning function (page 39) to store your
device’s remote control signals in the included remote control unit.
For instructions on resetting the preset memory, see page 42.
1 2 3
4 5 6
7 8 9
0
PRE
LRN
CALL
PUNCH
BLKT
RST
TV
CD CDR MD TAPE ZONE2 DVD
VDP CABLE DBS VCR2 VCR1
It is also possible to select the mode directly using the
mode buttons.