Denon 1083 - Manual (Page 27)

27
Setting the Dolby Digital Setup
Sets the down-mixing method when not using a center speaker or surround speakers.
OFF: The dynamic range is not compressed.
ON: The dynamic range is compressed automatically according to the combination of speakers being used.
1 At the System Setup Menu select “Dolby Digital
Setup” and press the ENTER button.
2 Select “ON” if you want to use the Dolby Digital Down-mix, “OFF” if
you do not want to use it.
3 Enter the setting.
The System Setup Menu reappears.
[1] Setting the power amplifier assignment
Make this setting to switch the power amplifier for the surround back channel to ZONE2.
If ZONE2 is selected, the signal that selected at ZONE2 is output at “SURR. BACK/ZONE2 PREOUT” terminals.
1 At the System Setup Menu select “Zone2 Control”
and press the ENTER button.
Setting the ZONE2 Control
2 The “Zone2 Control” screen appears.
Select “Power Amp Assignment” and press the
ENTER button.
3 Select “Surround Back” to use as the surround back
channel, “Zone2” to use as Zone 2 out.
When “Surround Back” is selected When “Zone2” is selected