Denon 1083 User Manual

Page 23

Select the mode.
Select “Auto” or “Manual”.
• Auto:

Adjust the level while listening to the test tones produced
automatically from the different speakers.

• Manual:

Select the speaker from which you want to produce the test tone to
adjust the level.

Select “Surr. Sp.”, then select the surround speaker(s) from which you want to produce the test

tone (A, B or A+B).

• Surr. Sp.: A

Adjusts the balance of the playback level between the channels when using surround speaker A.

• Surr. Sp.: B

Adjusts the balance of the playback level between the channels when using surround speaker B.

• Surr. Sp.: A+B

Adjusts the balance of the playback level between the channels when using surround speakers

A and B at the same time.

The “Surr. Sp.” can only be selected when both surround speakers A and B have been selected

at the System Setup Menu (when both A and B have been set to “Large” or “Small”).

Example: When the “Auto” mode is selected

Select “Test Tone Start”.

Select “Yes”.

a. If the “Auto” mode is selected:

Test tones are automatically emitted from the different speakers.
The test tones are emitted from the different speakers in the
following order, at 4-second intervals the first time and second time
around, 2-second intervals the third time around and on:

Use the CURSOR left and right buttons to adjust all the speakers to the
same volume.
The volume can be adjusted between –12 dB and +12 dB in units of
1 dB.

b. When the “Manual” mode is selected

Use the CURSOR up and down to select
the speaker for which you want to output
test tones, then use the CURSOR left and
right to adjust so that the volume of the
test tones from the various speakers is
the same.

Example: When the volume is set to –11.5 dB

while the test tone is being
produced from the Front Lch
speaker

Example: When the volume is set to –11.5 dB

while the Front Lch speaker is
selected

Flashing

SBR

SBL

1spkr

2spkrs

When the surround back speaker setting is set to “1spkr” for
“Speaker Configuration”, this is set to “SB”.