American Time H004228 Master Clock Synchronizer - Manual (Page 3)

2
© American Time
SiteSync IQ Master Clock
Synchronizer
Connecting the Master Clock Synchronizer Module
Figure 2 – Master Clock Synchronizer connections
To install your Master Clock Synchronizer module you will need to make two connections.
1. Connect power to the module using the DC power adapter supplied with the module from an AC wall outlet.
Connect the adapter to the port indicated in figure 2.
2. Connect your time setting dry contacts to the module indicated in Figure 2.
LED Function
LED1 - Red = No signal 2 minutes
Green = Signal last 2 minutes
LED2 - Green = Relay active
LED3 - Yellow = Message Rec’d - A single yellow flash will indicate the relay activation message is received.
Dry contact wire
connections
DC
Power
Adapter
RJ45
Configuration
Port RJ11
Factory
Use Only
LED1
LED2
LED3