WaveWare API-64 Alarm Monitoring User Manual
Page 6
There is one block of four dip switches on the circuit board inside the unit.
Set The Dip Switches for Each Expansion Module Using the Table Below:
Expansion Module Dip Switch Settings Station Number
1 2 3 4
1st API-64EM off off off off 02
2nd API-64EM on off off off 03
3rd API-64EM off on off off 04
4th API-64EM on on off off 05
5th API-64EM off off on off 06
6th API-64EM on off on off 07
7th API-64EM off on on off 08
8th API-64EM on on on off 09
9th API-64EM off off off on 10
10th API-64EM on off off on 11
11th API-64EM off on off on 12
12th API-64EM on on off on 13
13th API-64EM off off on on 14
14th API-64EM on off on on 15
15th API-64EM off on on on 16
(4)Plug an AT/WIN95 Compatible Keyboard into the 5 Pin Socket Labeled "KEYBOARD".
(5)Connect the API-64 to the paging terminal or to the API-64RM via the DB-25 connector labeled "RS-
232" using the cables supplied with the system.
(6)Connect the API-64 to the parallel system printer (if one is being used) to the DB-25 connector labeled
"PRINTER".
PAGE 3-3
(7)Turn the API-64 (and all expansion modules) on using the toggle switch labeled "POWER ON" that is
located on each unit. Program the API-64 and all API-64EM modules connected to the system using the
Programming Instructions that start on page 4-1.
Back To Index
CHAPTER 4
PROGRAMMING INSTRUCTIONS
API-64/API-64EM PROGRAMMING NOTES
1.Use the Directional Arrow Keys (
while programming. When the cursor has been moved to a field, the data in that field will flash. The data
for that field can then be altered using the instructions below.
2.Use the
3.Use the
throughout programming procedure .
4.Use the
programming changes have been saved, the changes will not be saved.
5.If the system is paging "GOLAY" type alphanumeric pagers (the paging supplier or system manager can
provide that information) the following characters in a message string are invalid:
Back To Index