beautypg.com

Toyotomi FB-38N(FS) User Manual

Page 17

background image

17

ERROR CODE IN DISPLAY


When the water heater is malfunctioned, the unit stops the operation automatically and Display
indicates Error Code (“E” & “Number”) alternately by flashing.

Display CAUSE

RESULT

E + 0

Disconnected model setting jumper terminal

E + 2

Flame sensor detected flame before ignition

E + 3

Disconnected thermistor

E + 4

High limit switch activated

E + 5

Tip-over switch activated

E + 6

Extinguished after ignition

E + 7

No ignition

Out of fuel
Refuel

E + 8

Blower motor malfunction

E + 9

Heat exchanger bi-metal switch
or Thermal fuse activated

E +

E +

Ξ

E +

Malfunction of remote controller or remote controller
cord

Operation stops
and operation
lamp and display
are flashing.


NOTE: To restart the unit, tunr the unit off by pressing “POWER SWITCH” and after 5 seconds

press “POWER SWITCH” to turn it on once again.


NOTE: Press the Reset Button of Heat Exchanger Bi-metal Switch to reset the unit when Heat

Exchanger Bi-metal Switch is activated. Make sure to disconnect the Power supply
cord before pressing the Reset Switch of Heat Exchanger Bi-metal Switch.

This manual is related to the following products: