Denso CU-7011 - Manual (Page 17)

7
6.3 Communication with the Host Computer
This section describes how to start communication with the host computer according
to the FTP in System Mode.
(1) Turn on the host computer.
(2) On the host computer, start the FTP server program.
(3) Turn on the BHT and run System Mode. Set the TCP/IP parameters (incl. IP
address and subnet mask)) and FTP parameters (incl. server IP and user ID).
(4) Put the BHT on the CU-7011.
BHT
CU-7011
Take care not to put the hand strap or get any foreign material between the CU
and BHT. The BHT may fail to communicate with the host.
(5) To upload a file from the BHT according to FTP, choose "FTP" on the SYSTEM
MENU in System Mode and then choose "UPLOAD."
To download a file from the host computer, choose "FTP" and "DOWNLOAD."
For details about the operating procedure, refer to the BHT User's Manual "LAN
Support Version."
The DATA LED will come on upon start of communication. After completion of
communication, the LED will go off.