Denso CU-7011 - Manual (Page 15)

5
Chapter 6 Connecting to Ethernet
6.1 Setting the Transmission Speed of the CU-7011
Set the transmission speed of the CU-7011 to the same value as that of the BHT, by
using the DIP switch provided on the bottom of the CU-7011.
(1) Unplug the AC adapter from the wall socket.
(2) Turn the CU-7011 upside down.
(3) Remove the protection sheet of the DIP switch from the CU-7011.
(4) Set the selectors of the DIP switch as shown below.
ON
OFF
1 2 3
O N
ON
OFF
1 2 3
O N
DIP switch
(Protection
sheet already
removed)
Bottom View
For 115.2k bps
For 4M bps
(5) Reinstall the protection sheet.
(6) Plug the AC adapter into a wall socket.
• Do not set the DIP switch to any configurations other than either of the two
shown above.
• When the power is turned on, the DIP switch settings will be read in.
ON
2 3 1