Brennenstuhl Flat Light Jet-Light 36Watt IP44 5m H07RN-F 2x1,0 2x18W 2x1200lm Energy efficiency class B - Manual (Page 11)

Jet-Light 2 x 18 W, FL-18
Operating instructions Stand: FL-06-2011_K
6 Operation and assembly
Please note the following information, particularly the safety information, in order to avoid operating
errors and possible defects.
7 Using for the first time
Assemble the Jet Light as shown in the diagram:
IMPORTANT: Check all the screw connections before using for the first time.
8 Changing the tubular lamps and the starter
DANGER:
Remove the plug from the mains before opening the lamp!
Allow the Jet-Light FL-18 to cool down before touching it (at least 15 minutes).
Touching it while hot could cause burns. Use only 110 V – 130 V starter!
Step Procedure (tubular lamps)
1 Unscrew the protective cover
2 Remove light bulb
3 Remove distance piece
4 Slip distance piece over new lamp
5 Insert new light bulbs applying light pressure until they lock into place
6
Replace protective cover
Ensure that the seal between the housing and the protective cover is
correct
3
4
Step Procedure (starter)
1 Unscrew the protective cover
2 Gently twist the starter to the left and pull out (bayonet fitting)
3 Insert the starter and lock into place by gently twisting to the right (bayonet fitting)
4
Replace protective cover
Ensure that the seal between the housing and the protective cover is correct