Brennenstuhl High Performance LED Lamp L903 IP55 9x3W 1675lm white Energy efficiency class A - Manual (Page 8)

8
D
Operating Instructions Premium LED spotlight /zone lighting
TECHNICAL DATA
Nominal voltage: 220–240 V~ 50 / 60 Hz
Nominal power: 27 x 0,5 W LED
Protection type: IP 44
Protection class: I
The LED lamp is solely for normal use and not designed for raw operation.
Motion detector range: 180 ° and max. 10 meter, adjustable
Duration: adjustable from 10 (+/– 5) seconds up to 4 (+/– 1) minutes
Ambient temperature: –15 °C – + 45 °C
INSTALLATION
Notice: The lamp must be installed on a dry, stable and solid surface in accordance with the
specifications in Fig. B. Ideally, the LED lamp should be installed 1.8 to 2.5 above the ground (see
Fig. B).
Install the lamp (see Fig A)
Release the screw
1 on the terminal box, press the unlock button 3 and remove the assembly
plate 4 . Use the assembly plate to mark the positions of the screw holes on the assembly surface.
Important: Make sure not to drill into any hidden lines. Guide the power cable through the cable
bushing
6 on the assembly plate and attach it to the wall using the screws 5 and dowels 7 .
Attach the power cable to the lustre terminal 2 in accordance with Fig. A (N = blue cable,
= green / yellow cable, L = brown cable).
Reattach the body of the lamp to the assembly plate. To do this, press the unlock button 3 and
slide the lamp onto the assembly plate until the unlock button 3 locks back into place. Secure the
connection by screwing it to the terminal box 1 .
Set the desired direction of the light and tighten the screws. Switch the main power supply on.
Only for model SH 2705 PIR IP 44 and LH 2705 PIR IP 44
The motion detector should not be directed at heat sources such as grills, air conditioners, other
outside lighting, moving cars and exhaust shafts in order to avoid annoying false triggering. For
the same reason, the motion detector should not be installed in areas with strong electromagnetic
interference. Do not direct the device at reflective surfaces such as smooth white walls, swimming
pools, etc.
The technical specifications for the sensor range (max. 10 meter at 180 °) can vary slightly
depending on the installation height and location. The sensor range on the device can also
change if the temperature changes. Before you select the installation location for the device, you
should know that the motion detector reacts most sensitively to movements that run straight
across its range and least sensitively to movements that run directly toward or away from the
motion detector (see Fig. C). If the movement is directly toward or away from it, this means a
significant reduction of the sensor range (see Fig. C).
BA_City_LED_Horizontal_A5_130723.indd 8 23.07.13 16:53