Installation, Ab c – Audio Solutions FM3242 User Manual
Page 8
8
SteP 5
NOTE: Angle adjustment should be done by at least two people.
•
(A) While another person is holding the television assembly, use the included allen wrench to loosen
the two screws on either side of the mounting plate and tilt the television up to 5 degrees back or 15
degrees forward. Tighten the screws when the desired angle is achieved. See Figure 6.
•
(B) With assistance, adjust the main cantilever bracket to move the television out from the wall and
angle up to 45 degrees either left or right. Pay attention to wiring to ensure cables are not damaged
during angle adjustment. See Figure 6.
•
(C) Extend the bracket arm fully and then use the attached cable clips to secure cable to the arm. See
Figure 6.
A
B
C
Figure 6 - Adjust Angle
INStAllAtION