Weston Roma Deluxe Electric Tomato Strainer - Manual (Page 5)

-5-
DISASSEMBLY & CLEANING INSTRUCTIONS
OUTLET INSTRUCTIONS
This appliance has a polarized plug (one prong is
wider than the other). To reduce the risk of electric
shock, the plug must fully fit into the electrical outlet.
If the plug does not fit, turn it over and try again. If the
plug still does not fit, contact a qualified electrician
in regards to updating the electrical outlets in your
home. DO NOT modify the plug in any way.
WARNING! Before cleaning, assembling or disassembling the Tomato Strainer,
make sure it is turned off “O” and disconnected from the power source. Test to make
sure there is no power to the Motor by switching the Motor on “-” and off “O”.
Before using the Tomato Strainer for the first time, thoroughly clean all parts (including
accessories) as instructed below. DO NOT immerse the Motor in water or other liquid.
1. Turn the Motor Unit off “O” and disconnect it from the power supply.
2. Remove the Hopper from the Head.
3. Turn the Head Locking Nut counter-clockwise to loosen the Head from the Motor.
Push the Head/Screen Assembly forward slightly while lifting out the back end of the
Head/Screen Assembly removing it from the Motor.
4. Turn the Front Ring Nut counter-clockwise to remove it from the Head.
5. Disassemble all the parts from the Head/Screen Assembly.
6. Gently turn the Chute clockwise to unhook the tabs on the Motor.
7. WARNING! DO NOT immerse the Motor in water or other liquid. Clean the Motor
with a damp cloth or towel then wipe dry. Wash all parts that contact food in warm soapy
water. Rinse with clean water. Dry all parts immediately.
NOTE! Only plastic parts of the Tomato Strainer are top-rack dishwasher safe.
8. Coat the Screens, Head and Drive Shaft Assembly with a food-grade silicone spray.
NEVER immerse the Motor
in water or other liquid.
Clean it by wiping with a
damp cloth.