Weston Non-Stick Single Hamburger Press - Manual

REV101409
SINGLE
HAMBURGER
PRESS
INSTRUCTIONS
MODEL #07-0301
1. By holding on to the top of the Hamburger Press, screw the Adjustment Plate and
Adjustment Screw into the top of Hamburger Press by turning clockwise until
approximately half the threads are showing on top of the Hamburger Press.
2. Re-thread the Locking Wing Nut onto the Adjustment Screw. Pay special attention
not to cross-thread any parts when assembling.
3. Screw the Thickness Adjustment Knob clockwise onto Adjustment Screw until finger
tight.
ASSEMBLY
PATENTED
CLEANING & DISASSEMBLY
1. Completely remove the Thickness Adjustment Knob and the Locking Wing Nut from
the Adjustment Screw by turning counter-clockwise.
2. Hold on to the top of the Hamburger Press and turning counter-clockwise,
unscrew the Adjustment Plate and Adjustment Screw from the Hamburger
Press.
3. Clean all parts in warm soapy water, then thoroughly dry.
ATTENTION
If any components of this unit are broken,
do not operate properly, or for product returns,
please contact Pragotrade LLC at
1-800-814-4895
Outside the U.S. call 440-638-3131.
For the online catalog, log onto www.westonsupply.com.
Exclusively imported by Pragotrade LLC Strongsville, Ohio
www.pragotrade.com
LLC
u.s.a.