Definitive Technology IWSUB10/10 - Manual (Page 4)

Important Note Concerning Your IWSub 10/10
and SubAmp 600
Your IWSub 10/10 is specifically designed to be used in conjunction with
the Definitive Technology SubAmp 600 and should never be used with another
amplifier. You will not achieve optimal performance, and you may cause dam-
age to your IWSub 10/10 if you attempt to power it using another amplifier or
receiver. BECAUSE OF THIS, THE IWSUB 10/10 WARRANTY IS VOIDED
IF AN AMPLIFIER OR RECEIVER OTHER THAN THE DEFINITIVE
TECHNOLOGY SUBAMP 600 IS USED TO DRIVE THIS SUBWOOFER.
Installation
Mounting Your SubAmp 600 In An Audio Rack
Your SubAmp 600 features side mounting brackets for use in professional audio
racks. When installing the SubAmp 600 in either professional audio racks or
in AV rack furniture, be sure to leave adequate ventilation space around the
SubAmp 600 unit.
Tools Required for IWSub 10/10 In-Wall Installation
• Pencil for marking the location of installation.
• Keyhole saw or utility knife for cutting drywall.
• Level.
• Screwdriver, preferably powered, with Phillips head bit.
• Power drill with appropriate bit (optional, for starting wall cut).
• Template (included: 14
3 /
8
" x 19 7 /
8
").
• Gasket material (included).
1. The IWSub 10/10 is designed to be located between two vertical studs,
inside a space of 14 1 /
2
"–15 1 /
2
", with the long dimension of the speaker
oriented vertically. If your studs are spaced wider than this, you will have to
shim one side of the inner wall space to properly secure the speaker in a
14
1 /
2
"–15 1 /
2
" space.
Mounting Bracket Mounting Bracket
4