Ubiquiti Networks UniF AP AC Outdoor - Manual (Page 45)

42
Chapter 9: Access Point Details UniFi ® Controller User Guide
Ubiquiti Networks, Inc.
Access Point - Pending Approval
The Pending Approval state indicates that the Access Point
is in the default state and is available for adoption.
MAC Address Displays the MAC address of the Access
Point.
Model Displays the model number.
Version Displays the version of software used on the
Access Point.
Last Seen Displays the amount of time that has passed
since the Access Point was last seen.
Adopt Click Adopt to adopt the Access Point so you can
manage it using the UniFi Controller software.
Forget this AP/Move
Forget Remove the Access Point from management by
the UniFi Controller software and reset it to factory default
settings.
Note: Use caution when clicking Forget. This will
restore the Access Point to factory settings when
it is in a Connected state. Do not use the Forget
option when the Access Point is in an Isolated or
Disconnected state. If you do, the only way to make
the Access Point accessible from the UniFi Controller
is to take it down and connect by wire.
Move to To move the Access Point, select another site
from the drop-down menu.