Spectrum Controls 140 MPM 204 00sc - Manual (Page 25)

Meter Proving Module
27
application programming examples.
T T T T Table 3-2 Module Files able 3-2 Module Files able 3-2 Module Files able 3-2 Module Files able 3-2 Module Files
File Name File Name File Name File Name File Name Installation Disk Dir Installation Disk Dir Installation Disk Dir Installation Disk Dir Installation Disk Director ector ector ector ectory y y y y Description Description Description Description Description
GCNFTCOP.SYS \MODSOFT\ ModSoft I/O map module definitions
LMSFDT.SYS \MODSOFT\ ModSoft zoom screens
QUANTUM.SYS \MODSOFT\ Quantum help screens for ModSoft
SCIOCFG.EXE \CONCEPT\ Spectrum utility that runs under Concept to provide help setting
up configuration I/O files; this is a 32-bit Windows program requiring Windows 95/98/NT
SPECTRUM.HLP
\CONCEPT\ Spectrum I/O for Quantum module help file
SPECTRUM.MDC \CONCEPT\ Spectrum I/O for Quantum module definition file
Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft
For ModSoft (version 2.4) to recognize the Quantum counter module, you must update the software with the
LMSFDT.SYS, GCNFTCOP.SYS, and QUANTUM.SYS files. You should also install the ModSoft example
files at this time. See “
Setting Up the Configuration Software. Setting Up the Configuration Software. Setting Up the Configuration Software. Setting Up the Configuration Software. Setting Up the Configuration Software. ”
To install the runtime files for ModSoft:
1. 1. 1. 1. 1. Identify the path in which ModSoft is installed, for example, C:\MODSOFT\.
2. 2. 2. 2. 2. Insert the installation disk in the drive (probably A:).
3. 3. 3. 3. 3. From MS-DOS on the PC, enter the following command (assuming installation from the A: drive):
C:\> COPY A:*.SYS C:\MODSOFT\RUNTIME\
4. 4. 4. 4. 4. Verify that the files have been copied to the C:\MODSOFT\RUNTIME\ directory.
5. 5. 5. 5. 5. Verify that the example files have been copied to the C:\MODSOFT\PROGRAMS\ directory.
Setting Zoom Registers Using ModSoft Setting Zoom Registers Using ModSoft Setting Zoom Registers Using ModSoft Setting Zoom Registers Using ModSoft Setting Zoom Registers Using ModSoft
The procedure below tells how to enable the zoom registers and make configuration settings in ModSoft. Refer
to “
Zoom Register Layout. Zoom Register Layout. Zoom Register Layout. Zoom Register Layout. Zoom Register Layout. ”
1. 1. 1. 1. 1. Ensure that the ModSoft configuration software has been updated from the module installation disk, as
described in “ Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft Setting Up ModSoft ” .