Spectrum Controls 140 MPM 204 00sc - Manual (Page 18)

Quantum Series 140 MPM 204 00sc
20
Removing and Replacing the T Removing and Replacing the T Removing and Replacing the T Removing and Replacing the T Removing and Replacing the Terminal Block erminal Block erminal Block erminal Block erminal Block
When wiring the module, it is not necessary to remove the terminal block. However, if necessary, you can use
this procedure for removal and replacement.
1. 1. 1. 1. 1. Loosen the upper and lower retaining screws, alternating between screws. The terminal block backs
away from the module as you remove the screws.
2. 2. 2. 2. 2. Carefully pry the terminal block loose.
3. 3. 3. 3. 3. When ready to replace the terminal block, insert and tighten the retaining screws. Torque the retaining
screws to 0.46 Nm (4.1 in-lb).