Lingenfelter L350xx0000 Lingenfelter Momo Shift Knob v1.4 - Manual (Page 5)

Page 4.
6. Push the shift knob onto the shift lever until
it bottoms out. Applying constant downward
pressure on the shift knob, tighten the
three (3) set screws in a uniform manner to
secure and center the shift knob onto the
gear lever.
NOTE: Make sure to maintain the proper
shift knob alignment as you are tightening
the set screws.
7. Screw the black threaded ring onto the base
of the shift knob.
Installation of the LPE Momo shift knob is
now complete.
5. Insert three (3) of the supplied set screws
into the holes on the LPE shift knob. If your
gear lever measured either 8mm or 10mm in
diameter, use the longer 6mm set screws. If
your gear lever measured 12mm or larger in
diameter, use the shorter 5mm set screws.
Make sure not to turn the set screws too
far into the shift knob as it will prevent the
shift knob from fitting over the gear lever
properly.