Konig Electronic Wireless alarm system - Manual (Page 7)

ENGLISH
7
The slightest vibration will trigger the sensor. It’s not recommended to
install the vibrate sensor on windows near to doors. Slamming doors will
trigger the sensor.
4. Insert, according the diagram inside the battery compartment, (backside)
the batteries for PIR sensor (3x AAA). The PIR sensor needs to warm up for
30~40 seconds for first use. In this period it cannot detect motion. Install
the PIR sensor at a height of 1~1.5 m for best performance. Do not install
the PIR sensor into direct sunlight, facing towards windows, objects that
move easily and heat or cold source.
5. Remove the transparent front cover of the alarm unit to write down the
position of the sensors corresponding with the numbered LED. (e.g. sensor
1=front door, 2=kitchen window, etc.).
6. Install the alarm unit to a location. The distance between the alarm unit and
the most far away sensor may not exceed 60 m (open area)*.
7. Switch on the alarm unit to ALARM or CHIME function. If switched to
CHIME, the alarm unit will sound like a door bell when a door or window is
opened. Switched to ALARM generates a 100 dB loud siren. When the alarm
unit is switched on, the alarm is not armed (active) yet. Push the ON button
on the remote control to arm the alarm and OFF to disarm. The delay time
for entering and leaving the protected area is between 20~25 seconds.
8. It’s recommended to test the alarm system for correct operation with first
use and every 3 months.
Procedure:
a) Switch on the alarm unit to ALARM or CHIME (for testing recommend).
b) Push the ON button on the remote control to arm the alarm.
c) Wait for 20~25 seconds (delay time).
d) For testing door/window sensor, open every door or window one
by one and check if the corresponding LED lights up and the CHIME
sounds.
e) For testing PIR sensor, move around the PIR sensor and check if the
corresponding LED lights up and the CHIME sounds. Note: the LED
indicator on the PIR sensor lights up also.
f) For testing vibrate sensor, hit carefully on the window and check if the
corresponding LED lights up and the CHIME sounds.
g) Disarm the alarm if everything operates correct.
h) The alarm system is ready to use.