Hatteland Display HM C01 (Rugged) - Manual (Page 20)

20
IND100210-2
General Installation Recommendations
Installation
PCI Card removal / replacement - Half Lenght & Full Height
Note: Areas of interest are marked in this section with circles and arrows in RED color. Please disconnect ALL
cables from the computer unit before proceeding!
1: Place the PCI Half Length bracket as shown and
push/slide it in so it reaches the end of the PCI card.
2: Mount 2 screws on top to fasten the PCI Half Length
bracket. Turn clockwise using a Pozidriv #2 screwdriver.
Repeat the procedure backwards to finalize operation.
PCI Card removal / replacement - Half Lenght & Half Height
Note: Areas of interest are marked in this section with circles and arrows in RED color. Please disconnect ALL
cables from the computer unit before proceeding!
1: Place the PCI Half Length/Half Height bracket as
shown and fasten it with 2 screws on the top. Turn
clockwise using a Pozidriv #2 screwdriver.
2: Notice the screw at the end of the bracket. By turning
this clockwise using your fingers the support piece will be
pulled downwards and towards the edge of the PCI card,
thus making it secured. Use a fair amount of force.