Hall Research VSA-HA-DP User Manual
Page 7
5
© Copyright 2014. Hall Research, Inc.
All rights reserved.
HDMI Wall Plate with Audio Extraction
Similar to Video EDID, you can control how the parts of the EDID table
that pertain to audio capabilities are constructed. Clicking these controls
selects either PASS-THRU, 2 CHN or MULTI modes
AUDIO EDID
2 CHN – EDID from SINK is set for 2 channel LPCM audio with 2 speakers.
MULTI – EDID from SINK is set for LPCM, DTS and Dolby audio with multiple speakers.
PASS-THRU – EDID from SINK is used
2-Channel is the FACTORY DEFAULT setting. Since the VSA-51 has a stereo 2-channel
audio amplifier, it is best to have the EDID set for two channel regardless of what is
connected downstream.
EDID Routing Modes
On HDMI output
Mute Audio
Clicking this control removes the audio portion from the HDMI video output (on the VSA-
51 HDMI output connector). You can use this command to make sure no audio comes
out of the display's built-in speakers.
FACTORY DEFAULT is not muted.
Cycle HPD
Misc
Clicking this control sends causes a 0.5 second pulse on the
Hot Plug Detect signal that is sent to the video source. So
basically the source will see an unplug and a re-plug. It has the
same effect of unplugging the HDMI input cable and plugging it back in. This forces the
source to re-initialize its HDMI video output connection (read EDID, and implement
HDCP if required) This indicator is ‘filled green’ when the source is connected.