American Sanders B-2+ Edger - Manual (Page 2)

- 2 - Clarke ® American Sanders Operator's Manual (CE) - American B-2
Operator Safety Instructions ........................................................ 3
Introduction and Machine Specifications ..................................... 5
Machine Set-Up ........................................................................... 6
How to Operate the Machine ....................................................... 8
Sanding Cuts and Sandpaper .................................................... 9
Maintenance .............................................................................. 10
The Dust Control System ..................................................... 10
How to Adjust the Angle of the Sandpaper Disc to the Floor 10
How to Change Adjustment of Machine ............................... 10
How to Clean Ventilation Plug .............................................. 10
Lubrication.............................................................................11
How to change the Lubricant in the Gearbox ........................11
How to Check the Carbon Brushes .......................................11
Lower Assy ........................................................................... 14-15
Upper Assy ........................................................................... 16-17
Wiring Diagram .......................................................................... 18
Contents of this Book
WARNING!
The Products sold with this Manual contain or may contain chemicals that are known to certain governments (such as the State of
California, as identified in its Proposition 65 Regulatory Warning Law) to cause cancer, birth defects or other reproductive harm. In
certain locations (including the State of California) purchasers of these Products that place them in service at an employment job site
or a publicly accessible space are required by regulation to make certain notices, warnings or disclosures regarding the chemicals
that are or may be contained in the Products at or about such work sites. It is the purchaser’s responsibility to know the content of,
and to comply with, any laws and regulations relating to the use of these Products in such environments. The Manufacturer disclaims
any responsibility to advise purchasers of any specific requirements that may be applicable to the use of the Products in such
environments.