American Energy Systems Crossfire Pellet - Manual (Page 16)

Version 4.0 16
9. Heat settings are changed by pressing the red or blue arrow buttons. Note: Inlet air
adjustments will/may be required for each temperature setting change. It is best to
only change one level at a time and allow the stove to stabilize.
10.
See information on required Cleaning in the maintenance section of this manual.
FIGURE 3
REFERENCE OPERATING INFORMATION
(SEE FIGURE #3)
• DO NOT turn main power switch “OFF” during stove operation. The stove must
complete normal cool down cycle prior to shutting power off. (Failure
to do so could cause a backup of smoke into the heating area if the stove is not
properly vented)
• The Room-Air blower has power to it at all times and will run continuously when
the main power switch is in the on position.
• After initial ignition and system start up, allow the stove adequate time to burn and
heat up at the preset #3 level prior to increasing heat setting.
Combustion Air Control
On/Off Button
(Control Board)
Power Switch