Agri-Fab 190-521-000 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
18.
Assemble hitch bracket to drawbar tongue,
using 3/8"
X
1" long hex bolts (R), lock washers
(1) and hex nuts (C). See figure 12.
20. Assemble large diameter flat washer (D), wheel,
another flat washer (D), cotter key (B) and hub
cap (E) to each axle end.
19. Assemble axle, (2) tube spacers and draw bar
tongue to wheel support keeping open side of
tongue facing up, make sure that latch lock
snaps over latch stand. Secure axle to wheel
support or axle brackets, using 1/4" x 1-3/4"
long hex bolts (J), lock washers (K)) and hex
nuts (L). See figure 13.
NOTE
Position valve stem to outside when
installing wheels on axle. See figure
14.
AXLE
COTTER KEY (B)
WHEEL
FLAT WASHER (D)
VALVE STEM
(outside)
FLAT WASHER (D)
HUB CAP (E)
FIGURE 14
FIGURE 13
21, Turn cart assembly over to rest on wheels. This
completes the cart assembly. Be sure to read
safety rules and operating instructions before
using your new utility cart.