Agri-Fab 190-521-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
13.
Assemble latch stand bracket using four 1/4"
X
5/8" hex bolts (G), lock washers (K) and hex
nuts (L). See figure 8.
16.
Assemble wheel axle brackets (2) to wheel
support, using 5/16" x 3/4" hex bolts (M) and
lock nuts (N).
NOTE:
Place welded tubes to
middle, as shown in figure 10.
14.
Assemble two front top corner caps and two
bolts in top flanges through tailgate reinforce
ment bracket using 1/4" x 1/2" hex bolts (F),
lock washers (K) and hex nuts (L). See figure
9.
17.
Assemble latch lock subassembly to drawbar
tongue using 1/4" x 5/8" long hex bolt (G), lock
washers (K) and hex nuts (L). See figure 11.
15.
Tighten all bolts assembled in step 4 through
14, lower cart assembly to rest on top flanges,
with axle support up. See figures 10 and 13.