Agri-Fab 190-521-000 - Manual (Page 3)

1. Remove the hardware pack and all loose parts
from the carton. Be sure carton is empty before
discarding.
2. Layout all the parts as shown in figure 2.
3. Position the cart body halves (W) upright, on a
smooth level surface, as shown in figure 3.
A
CAUTION
To help prevent tipping of cart, assemble on a
smooth level surface such as a garage floor or a
paved driveway. Pay close attention to stability of the
cart body when it is in an upright position. DO NOT
LEAVE THE CART UNATTENDED IN UPRIGHT
POSITION.
The cart could be knocked over causing
personal injury or damage to the cart.
4. Assemble the bolts (F), the lock washers (K) and
hex nuts (L) to the holes in center flanges. Do not
tighten till step 15, page 5. See figure 3.
5. Position the wheel support (AB) in place on the
bottom of the cart. See figure 4.
6. Assemble wheel support to cart with eight slotted
head screws (O) lock washers (P) and hex nuts
(Q). The heads of the screws should go to the
inside of the cart bed as shown in figure 4. These
screws should be tightened after they are all
assembled.
POSITION CART BODY HALVES
WITH LARGER DIAMETER HOLES AT TOP
FIGURE 3 FIGURE 4