Hunter 28837 46 Pemberley - Manual (Page 8)

Programming
14-15
IMPORTANT: READ BEFORE YOU BEGIN TO PROGRAM
1
Remove mylar label covering display window.
2 The PM indicator will appear between 12:00
noon and 11:59 p,m. There is no AM indicator,
3 When the heating or cooling system is actually
operating, "HEAT" or "COOL" will appear on the
display.
4 If power is interrupted the batteries will keep all
programs.
If "LOW ВАТТ" appears on the display replace
the batteries.
When you first install the three AA batteries.t the thermostat automatically sets the day.,and ilma to. Monday, 1.2:00
a.m„ shows the current room temperature and is programmed for 68“ in heat mode and 78° in cool mode.
The first data you should enter is the current time and day of week. As the keys are pressed, the display will show
the data being entered.
i:
EXAMPLE:
If the unit
is being
installed at
9:15 pm,
Saturday,
to set the
thermostat,
you would
press the
keys in the
shown
sequence.
RETURN
MO
!г--оо IS
^\S--0Q
MO
PM
3-00
P Initial read-out after pressing reset button.
■ Current room temperature is 72“.
■ No indication of program number.
MO
PM
PM
PM
те
те 7г
: Press once. Temperature digits disappear, show
time set mode.
■ Press and hold until 9:00 p.m. appears on display.
Press and hold until 15 minutes appears on display.
Ш Press 6 times until Saturday appears on display.
M Returns to normal time and temperature.
■ If return is not pressed it will return automatically in
16 seconds.