Hunter 28837 46 Pemberley - Manual (Page 3)

Read This Before Installing Thermostat
4-5
IMPORTANT
I Read the entire installation section of this
Owner’s Manual thoroughly before you
begin to install or operate your Hunter
Thermostat
• Remove the mylar labei from the display
window.
INSTALUTION
2 All installation is normally performed at
your thermostat.
PROGRAMMING
3 You can practice programming before
installing your thermostat by inserting and
connecting the batteries as shown on page 13,
can be restarted- This feature will prevent
damage to your air conditioner compressor
caused by rapid cycling. It does not provide a
delay when there are power outages,
TEMPERATURE RANGE
6 Your thermostat can be programmed
between 40°F and 90°F. However, it will
display room temperatures from 32°F to
POWER FAILURE
7 Whenever the main power is Interrupted
or fails, the battery power retains the
programs and current time-
and following the instructions on page 14. This-
can be done while you relax in your favorite
chair and is a very good way to familiarize
yourself with all the functions of your Hunter
Thermostat.
OPERATION
4 Your Hunter Therniostat is designed to
operate with most gas, oil, electric or
forced hot water heating and air conditioning
systems. These have 24-voit or millivolt
controls and represent most central heating
and air conditioning units in use In the United
States. ■
This Hunter Thermostat will not control multi­
stage heating or
cooling systems.
COMPRESSOR PROTECTION
5 - The thermostat provides a 4-minute delay
after shutting off the compressor before it’
BATTERY WARNING
8 When the batteries are low, “LOW ВАТТ”
indicator on the display will flash. When
this happens, install new batteries {do not use
old batteries) as soon as possible. The
battery should last one year.
CAUTION: The batteries are the only source
of power used to operate your system. If
you do not replace the batteries, the display
will dim and your heating and cooling
system will stop operation.
(f you have questions about the installation or
.programming of the Hunter Thermostat, call us
at 901-745-9222 from 8AM to 5PM Central
Standard Time.