Hunter 28837 46 Pemberley - Manual (Page 15)

Programming
28-2Í5
NOTE; Tho temperatures you have entered will
NOT take effect immediately, but at the next
program time change. The Thermostat is pre-set
to 68®F in heat mode and 7 B ^ F in cool mode.
If you want a temperature other than 68°F o r 78°F
nght away, you must use the manual override
feature described below to enter the temperature
you want.
To Review The Current Temperature Setting:
When your entered program becomes effective,
the corresponding program number will appear on
the display.
After programming, confirm
the new programs by pressing
Press
for 2
seconds
or less:
Current time and temperature.
m 70 indicates the current setting of the therroQstat is
70"F. 68 shows the present room temperature as
6S®R
m If held for more than 2 seconds, you will manually
override your present temperature to a new setting
as explained below.
Manual Override of Program
If You Want to Change the Temperature Without Affecting Your Program:
Press and hold raise temperature. Press and hold to lower temperature.
Temporary Manual Override
In the following example, the present room temperature is 60‘’F and we want to raise the temperature to 70°F
temporarily until the next program.
■ Press arrow to display current set and room
temperatures.
■ Continue pressing arrow. After 2 seconds, the set
teniperature digits will blink and begin to increase
until the button is released at the desired setting (In
this case 7D'’F).
■ Program number disappears.
■ Press return or in 16 seconds it will return to
showing current time and temperature.
■ To display a manual override setting, press either
arrow for less than 2 seconds.
■ When arrow is released, the display will show
current time and temperature,
M Your thermostat is now in manual override mode to
70*^F until the next program indicator number has
disappeared until the next program time comes
into effect.