K-Edge K13-490 User Manual

Page 3

Install the mounting arm (K13-491) in the correct position shown below:

Install, but do not tighten, the M4 x 8mm Button Head bolt into the lower clamp half (K13-423).

Adjust the mounting arm (K13-491) to your desired position.

10. Torque the M4 x 8mm Button Head to 2 N-m.

Caution: Do not over-torque this M4 x 8mm Button Head screw.

Note: A small amount of temporary thread lock has been applied to the M4 x 8mm bolt at the factory, it is

recommended that an additional amount be added if this bolt were to be adjusted multiple times.

Note: It is strongly recommended that you periodically check all bolts to ensure proper torque.