Installation steps – K-Edge K13-490 User Manual
Page 2

2
Installation Steps:
1.
Separate the upper clamp half (K13-421) from the lower clamp half (K13-423) by removing the 2x M4 x 12 bolts.
2.
Install the clamp onto the right side (driveside) of the stem on the handlebar.
3.
Install the upper clamp half (K13-421) back onto the lower clamp half (K13-432).
4.
Install, but do not tighten, the 2x M4 x 12mm bolts back onto the clamp assembly.
5.
Position the clamp to your desired position.
6.
Torque both bolts equally to 2 N-m.