Kenwood TK 3100 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

9 Press the Monitor key again to

confirm the beep pattern of the

selected signalling number.

10 On the 2 channel modeL repeat

steps 3 to 9 to set up the other

channel.

Example of setting up a channel with QT tone no. 01:

1 After entering QT setup mode, select channel 1.

2 Press and hold the PTT switch until a 1 second tone

sounds, to select 0 for the 10’s digit (approximately
2 seconds).

3 Wait for 2 seconds.

A 1 second tone will sound to confirm that 0 has been

selected.

4 Press the PTT switch 1 time to select 1 tor the Ts

digit,

A beep sounds when you press the PTT switch.

5 Wait for 2 seconds.

A short beep will sound to confirm that 1 has been
selected.

6 Press the Monitor key.

The green LED blinks twice.

7 Press the Monitor key again.

A 1 second tone will sound (0), there will be a short

pause, and then a short beep will sound (1) to confirm

that 01 has been selected.

15

This manual is related to the following products: