H. the tad and the auto-receive functions – Brother FAX-175 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
25
Let us change ICM to 4 messages of 28 seconds each. Follow this procedure:
1.
Turn the power OFF.
"CAUTION: BOTH ICM AND OGM MESSAGES WILL BE ERASED IN THE
EVENT OF A POWER INTERRUPTION. CARE SHOULD BE EXERCISED WHEN
UNPLUGGING THE UNIT OR TURNING OFF THE UNIT'S MAIN POWER
SWITCH.”
2.
Press the HOOK button and keep it depressed until the FINE lamp blinks as you turn
the power ON.
3.
4.
Press the FINE/PHOTO button five (5) times to select the Number of ICM Set Mode.
Press the START/COPY button to print out the current security code. You will see:
**** ***************/’
^CURRENT NUMBER OF |CM*********************
★
*
*
NUMBER OF ICM: 7
*
*
************************gpQ“|-|_j^p FAX”1 YS****************************
5.
To register the new number of ICM press FINE/PHOTO button four (4) times (for 4
messages).
6.
Press START/COPY button to register this digit and the unit will print out the
following:
**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? *******
* *
*
NEW NUMBER OF ICM: 4
**************************
*****************************
BROTHER FAX-175
The START/COPY lamp will start to blink when the printout is completed.
7.
If your entries are incorrect, press the STOP button and then the START/COPY
button. This wili bring you back to step 3 where you can select this procedure all over
again.
If your entries are correct, press the START/COPY button to complete the selection
of numbers. Now you have two choices. Choice (1) allows you to continue with
registration of other parameters. To do so, you press START/COPY button again
which will bring you back to step 3 above and where you can use the FINE/PHOTO
button to select the desired parameter. Choice (2) is to terminate the registration
process by pressng the STOP button.
NOTE: You can oniy use numbers 4 - 8 for FAX-175.
H.
The TAD and the auto-receive functions
If you have not set both, the TAD and the AUTO RECEPTION functions on your FAX-175 and
someone is calling your unit, these units wili, after 15 rings:
• Enter the TAD mode after 15 rings if the OGM is recorded and the ICM is not full. The
OGM will start after 15 rings. After completion of this call, the unit will revert to its
original status - no TAD and no AUTO RECEPTION.
or
Enter the AUTO RECEPTION mode if the OGM is not recorded or the ICM is full.