Brother FAX-175 User Manual

Page 18

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

The factory setting for this FOUR-DIGIT CODE is 0000. Here is an exampie of how you can
change this setting to 1204.

As shown on page 12, the process of registering theFAX PASSWORD starts by pressing the

FINE/PHOTO button once in step 3. The following steps are:

4. Press the START/COPY button to print out the password that is currently registered

in the unit. The foliowing wiii be printed out:

I. SETTING THE FAX PASSWORD

**★ * ***************,

CURRENT FAX PASSWORD

************************

FAX PASSWORD: 0000

**************************

BROTHER FAX-175

*ifk****irk**********1c***-k1c***1e

To register the new password press FINE/PHOTO button once to select the first digit

it<| II

Press START/COPY button to register this digit.

Press FINE/PHOTO button twice to select ”2".

Press START/STOP button to register the "2".

To register the third digit - "0" - press START/COPY button. This both selects and

registers a "0".

10. Press FINE/PHOTO button four times to seiect the finai digit "4".

11. Press START/COPY button to register this final digit and the FAX-175 wiil auto

matically print out:

**** DO YOU WISH TO MAKE THE FOLLOWING CHANGE? ******

NEW FAX PASSWORD: 1204

★

********************gpQ-p|_|^p FAX~1 Y^***********************************

The START/COPY lamp starts to blink when the printout is compieted.

12. If your entries are incorrect, press the STOP button and then the START/COPY

button. The FINE lamp starts to blink. This wili bring you back to step 3 where you
can select this procedure all over again by pressing the FINE/PHOTO button once and
going through the subsequent steps.

If your entries are correct, press the START/COPY button to compiete the selection

of numbers. Now you have two choices. Choice (1) aliows you to continue with

registration of other parameters. To do so, you press START/COPY button again

which will bring you back to step 3 above and where you can use the FINE/PHOTO

button to select thedesired parameter. Choice (2) is to terminate the registration
process by pressing the STOP button.