beautypg.com

The toll-saver feature, Iv. enhanced recording mode, A. ogm recording – Brother FAX-60 User Manual

Page 28: B. memo recording, C. how to change recording modes

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

22

The toll-saver feature

This function works on the

FAX-60

in the TAD mode as follows. The unit's TAD will answer

your call on:

• 5 rings if there is no message - then, after 5 rings the OGM will go on. Thus, unless you

wish to record a message on your unit via the remote TAD feature, you can hang up

before the 5-th ring and save the cost of a completed phone call.

• 2 rings if there is a message or messages. The OGM will start after 2 rings and you can

use remote control procedures to pick up the message.

• 2 rings if the ICM is full. Then, after 2 rings. Auto Reception will go on.

IV. ENHANCED RECORDING MODE

Use enhanced recording mode when using your

FAX-60

under adverse telephone line

conditions or if OGM and/or MEMO recording seem unclear during playback.

A. OGM recording

If enhanced mode is used for OGM recording, ICM message capability will be slightly reduced as

shown below:

ICM MESSAGE

SELECTION

4
7

ICM TIME PER MESSAGE

STANDARD OGM ENHANCED OGM

28 Seconds

16 Seconds

24 Seconds

14 Seconds

B.

MEMO recording

In standard recording mode the available recording time is the same as the ICM recording time.
In enhanced recording mode the available recording time is equal to 1/2 the ICM recording time.
If you unit is set for 4 24 seconds ICMs for example, then the memo recording time would equal
12 seconds.

C.

How to change recording modes

You can change the recording modes for either OGM or MEMO through user selectable switch
setting as shown below:

DIGIT

FACTORY SETTING

5

OGM standard recording (1)

8

MEMO standard recording (1)

OPTIONAL SETTING

OGM enhanced recording (0)
MEMO enhanced recording (0)

Refer to page 13 for a detailed description of how to set the user selectable switches.