I. transmission of documents – Brother FAX-60 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC FACSIMILE FUNCTIONS -

TRANSMISSION AND RECEPTION

TRANSMISSION OF DOCUMENTS

Insert the original document

face down

into the unit's scanner, aligning the document's

left edge with the document guide. The unit will pull the original partly into the scanner.

Insert one original sheet at a time!

(see 4-f below).

Set the

contrast switch

(bottom front of the unit) to match the image density of the

original

for dark,

for normal,

for light original, respectively).

Specify the FINE or PHOTO mode by pressing the

FINE/PHOTO

button. Unless you

specify either of these modes, the unit will automatically select the NORMAL modePlease
note that NORMAL offers the fastest transmission speed, followed by FINE and then

the PHOTO (the slowest).

Pick up the handset. After you hear the dial tone, dial the other party's number.

(a) If a voice answers, ask the other party to activate manual fax reception (if the

other unit is a Brother unit, the other party will push the

START/COPY

button;

if it is not a Brother unit, the other party may have to follow a different
procedure).

(b) If the other unit is set to automatic facsimile reception, you will hear the fax ready

tone. Press the

START/COPY

button. The

START/COPY

lamp will light up.

As the transmission starts, the lamp will stay on until completion.

(c) When the transmission is underway, replace the handset in its cradle.

(d) The original document will be pulled through the scanner.

(e) When a page is transmitted, the unit will emit a short beep.

(f) To transmit more than one page, wait for the short beep referred to in (e) and

putting out of the

ORIGINAL READY

Lamp which indicates that the first page

was transmitted, then place the second page into the unit

immediately.

The

document will be transmitted to the same telephone number as the original one.
You may continue to send additional documents in the same manner. If no new
document is fed into a scanner following the short beep, a long beep will sound
signifying the termination of the transmission mode. The unit will release the
phone line.

You can use the

REDIAL

button for automatically redialing the last number dialed (if, for

instance, it was busy when you first tried transmitting the document). To use this feature,
simply press the

REDIAL

button.

You may dial a number with the handset in its cradle. This can be done by pressing the

HOOK

button and then dialing the number.