Other operating instructions, For a rinse and spin, For a drain and spin – Whirlpool LT4900XS User Manual

Page 12: For a soak or pre-wash

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Other operating instructions

For a rinse and spin

You may need an extra rinse and

spin tor heaviiy soiled loads which

need more detergent. (Extra de
tergent can require an extra rinse.)

1. Push Control Knob in.

2. Turn clockwise to any • on the dial.

See above drawing.

3. Pull Control Knob out. The washer

will fill to selected level; agitate

2 minutes; drain and spin.

For a drain and spin

Your washer can be set to drain and

spin out water.

1. Push Control Knob in.

2. Turn clockwise to the bar just before

the OFF area in any cycle. See
above drawing.

3. Pull Control Knob out. The washer

will drain and spin.

For agitation and spin speeds in each cycle, see pages 8-11.

For a soak or pre-wash

For best results, use warm water

for soaking or pre-washing stained
laundry. Hot water can set stains.

1. Use recommended amount of

detergent or pre-soak product.

2. Push Control Knob in.
3. Turn clockwise to point at a

number

in the SOAK or PRE-WASFI

cycles.

4. Pull Control Knob out. The washer

will start.

5. When the cycle is over, add

detergent for the next selected
wash cycle. The SOAK cycie
shouid aiways be foiiowed by a
Wash Cycie.

important: See additional care

information In your “Laundry
Guide.”

To start the soak or pre-wash with agitation, the Cycle Control

Knob must point to the number in the SOAK Cycle.