Avlink CX-2088 - Manual (Page 24)

CX Matrix Switching System—User Manual
23
Examples for Selecting Matrix Switching Functions:
Example 1: Now there is a CX-2088 matrix having all the input/output ports properly
connected to the equipment. Then needed input/output ports are set to Audio/Video channel 1
while Output is being switched to channels 2, 3, 5. There are two ways of operations if you want
to switch Audio/Video channel 3 to output channel 6 as follows:
First Way: Make sure that the boxes to the left of “Video” and “Audio” have been selected.
Then, directly click the corresponding to turn it into ，thereby completing the
switching operation.
Second Way:
Step 1: Makre sure that you have checked the boxes to the left of “Video” and “Audio”.
Step 2: First select the “Output”number keys 02, 03 and 05 to the right, and select the “Input”
number key 01 to the bottom. Afterwards, press consecutively the previously selected “Output”
number keys 02, 03 and 05 (or you can press the “Deselect all output” key). This way, you have
selected “Input” 01 and “Output” 02, 03 and 05 switching.
Step 3: First select the “Output” number key 06 to the right, and select the “Input” number
key 03 to the bottom. Afterwards, press the previously selected “Output” number key 06 (or you
can press the “Deselect all output” key). This way, you have selected “Input” 03 and “Output” 06
switching.
Upon completion of the above 3 steps, you have actually completed the switching operation of
having Audio/Video channel 1 to Output channels 2, 3 and 5 while at the same time successfully
switched from Audio/Video channel 3 to Output channel 6.
Example 2: Now there is another CX-2088 matrix having all the input/output ports properly
connected to the equipment. You are required to set the Input/Output ports to Video channel 1
and switched to Output channels 1, 6 and 7 while Audio channel 2 is being switched to Output 8.
Follow the instructions below:
First Way:
Step 1: Makre sure that you have selected “Video” and not “Audio”. In the matrix, directly
click the coordinate icons that fall between the Input number key 01 and the Output
number keys 01, 06, 07 and the selected icons will turn . This way, you have successfully
completed video switching operation of selecting Input 01 and Output 01, 06 and 07.
Step 2: Make sure that you have selected “Audio” and not “Video.” In the matrix, directly
click the coordinate icon that fall between the Input number key 02 and the Output
number key 08 and the selected icon will turn . This way, you have successfully
completed the audio switching operation of selecting Input 02 and Output 08.