Avlink CX-2088 - Manual (Page 23)

CX Matrix Switching System—User Manual
22
7.0.1.2 Software Activation
First, you must turn off power both to the CX matrix and to the computer. Then, connect the
matrix RS-232 port to the PC RS-232 port using the bundled communication cable. (Refer to the
previous section “CX Matrix and Control Computer Connection.”;
Turn on power to the CX matrix and the computer:
Activate the AV Matrix.exe on the bundled CD-ROM in the control computer to enter the
control software interface.
7.0.2 Software Features
The software controls signal connection between the corresponding input port and output port
as required. The main operation window is shown in Figure 7-1 below:
Figure 7-1 《AV Matrix》Control Software Usage Interface
Scroll on the left lower corner to view contents as shown below.
7.0.2.1 Main Operation Interface Features
Refer to the window menu above, the interface blue area shows crossing matrix of output
ports 01-08 and input ports of 01-08. On the lower right hand corner, you can select either
“Video”or “Audio”for signal switching or “Disconnect”to close all output ports. Click to check
the white boxes to the left of “Video” and “Audio” for specified signal transimission.