AquaCraft VS1 User Manual

Page 10

4. Next, epoxy the front (longer) upright into the base.

5. To help strengthen the area that the O-rings attach to, it is
a good idea to place a few drops of thin CA on the hook end
of the uprights.

6. The completed mount.

INSTALLING THE FUEL TANK

Parts and tools you are going to need:
Pre-built mount (VS1 Kit)
Four 2 x 10mm wood screws (VS1 Kit)
Small Phillips screwdriver
Fuel tank (VS1 Kit)
O-rings (VS1 Kit)
Fuel line

1. Align the fuel tank mount’s front tabs in front of the forward
mounting block. Screw the mount in place using the four
2 x 10mm wood screws provided.

2. Carefully slip fuel line onto each fi tting on the fuel tank.
Place the fuel cell in the mount cradles and secure with the
included O-rings. If you like, you can cut the fuel line to length.
When doing so, make sure you have enough line length to
place the lower fuel line to the carburetor and the upper line
to the muffl er pressure. Note: Please use a fuel fi lter from the
tank to the engine carburetor.