AquaCraft P-27 Gunslinger - Manual (Page 4)

4 4 4
Transmitter
To help you better understand your transmitter and its functions,
here is a picture outlining the operational features.
1. Steering Wheel
2. LED power on indicator
3. Power ON/OFF button
4. Throttle trigger
5. Steering rate adjustment
(this is used to increase
or decrease the turning
radius of the boat)
6. Throttle reversing switch
(“R” is the position the
switch needs to be in for
your P-27 Gunslinger)
7. Throttle Trim dial (this
should be in the 2:00 o’clock position)
8. Steering trim (this is used to adjust the tracking of the boat)
9. Steering reversing switch (this should be in the “N” position
to operate your P-27 Gunslinger)
Assembly
INSTALLING THE TRANSMITTER BATTERIES:
1. Install 4“AA” batteries into the transmitter in the confi guration
molded into the battery fl oor. Slide the lower cover off the
bottom of the transmitter. Install the 4 AA batteries using the
battery positions marked in the lower battery tray. Slide the
battery cover back in place. It will snap into place.
2. Turn the transmitter “ON” by pressing the button on the right
side of the transmitter. The battery level indicator light (LED)
should glow red. If the LED is fl ashing the batteries are low
and need to be replaced or rechecked for incorrect installation.
BATTERY PACK INSTALLATION
1. Remove the canopy by rotating the lock near the front of
the hatch.
2. Lift and remove the cowl from the boat