AquaCraft Minimono - Manual (Page 9)

9
SHARPENING: It’s best to sharpen the turn fins to a
razor sharp edge. This will eliminate drag and reduce
lift. Remember as a rule of thumb, if it touches the
water it needs to be sharp or have sharp edges
TRIM PLATES: Bending the trim plates up or down controls
the ride of the boat. The trim plates help control porpoising.
Porpoising is when the boat bounces up and down as it runs
over the water. Keep in mind bending the trim plates down
too far can have negative results, causing the boat to draw
too much power and possibly damage the electronics.
ORDERING REPLACEMENT PARTS
To order replacement parts for the AquaCraft Minimono use the order numbers in the replacement parts list that follows. Replacement parts
can be purchased from your local hobby shop or by mail order. If you need assistance locating a dealer to purchase parts, vist hobbico.com
and click on “Where to buy”. If you are missing parts, contact Hobbico Product Support at:
Phone: 217.398.8970 Fax: 217.398.7721 E-mail: [email protected]
AQUB6234 Cowl
AQUB6267
Wire Drive with Prop Shaft
AQUB8752 Rudder Linkage Set
AQUB7907 Motor Coupler
AQUB9281 Turn Fin Plates
AQUG7003 Brushless Motor
AQUM3530 20-Amp LiPo Controller
AQUB8742 Rudder Support Brackets
AQUB8735 Rudder Assembly Complete
AQUB8736 Rudder