AquaCraft Miss Vegas - Manual (Page 4)

❏
2. Slide off the battery door on the bottom of the transmitter.
Install 8 fresh “AA” batteries into the bottom of the transmitter in
the configuration molded into the battery holder. Re-install the
battery door onto the bottom of the transmitter.
❏
3. Turn the transmitter on using the switch on the front. The
red LED light next to the on/off switch should light up. If the
LED does not light up, turn the transmitter off and check to
make sure that the batteries are installed properly. If you see
a flashing LED, the batteries are low and need to be replaced.
INSTALLATION OF RECEIVER BATTERIES
❏
1. Locate the cowl locks on the rear hatch cover and slide
them forward.
❏
2. Lift the rear of the canopy and slide it forward to access
the interior of the hull.
❏
3. Remove the two (2) 2 x 12mm screws that secure the
radio box lid and gently lift the lid from the battery box.
❏
4. Uncoil the receiver antenna and carefully thread it
through the rubber grommet on the radio box lid as shown.
❏
5. Run the receiver antenna through the antenna tube and
insert the tube into the grommet as shown.
Install (8) new "AA" batteries
ON / OFF
THROTTLE SERVO
REVERSE
STEERING
SERVO
REVERSE
POWER
LIGHT
STEERING
TRIM
ADJUSTABLE
STEERING
RATE
THROTTLE
TRIM
4