AquaCraft Miss Vegas - Manual (Page 3)

• Model engines generate considerable heat. Do not touch
any part of your engine until it has cooled. Touching the
muffler, cylinder head, or exhaust header may result in a
serious burn.
• Use safety glasses when starting or running engines. The
propeller may throw loose material such as sand or gravel
into your face.
If the buyer is not prepared to accept the liability associated
with the use of this product, the buyer is advised to return this
kit immediately in new and unused condition to the place
of purchase.
The U-18 Miss Vegas Hydroplane can be made ready for the
water in just a few minutes. The following items are required
to complete assembly:
❏
HCAP2520 Hot Shot ™ 2 Glow starter
❏
ODOP3130 30% Nitromethane model boat fuel (1 quart)
❏
DTXP0125 Kwik-Pit ™ 250 fuel bottle
❏
12 “AA” batteries (FUGP7316 – 16 pk)
It is a good idea to assemble a useful collection of tools and
accessories to bring along anytime you head out to the pond.
Here are some items you will want to keep handy.
❏
#2 Phillips screwdriver (HCAR1024)
❏
Hobbico ® heavy-duty diagonal cutter 7" (HCAR0627)
❏
Metric and standard hex drivers
❏
Adjustable wrench
❏
Needle-nose pliers (HCAR0625)
❏
After Run engine oil (HCAP3000)
❏
Glow plugs
❏
Fuel tubing (GPMQ4131)
❏
Hook & loop material (GPMQ4480)
❏
Hobby knife (HCAR0109)
❏
AquaCraft Speed Grease cable lubricant (AQUB9500) or
Marine-grade grease (for lubricating the flexible drive cable)
❏
Zip-ties
❏
Extra “AA” batteries
❏
Thread-locking compound
❏
CA glue and de-bonder
❏
Paper towels
❏
Spray-on glass cleaner
❏
Sunglasses
❏
Sun block
❏
Waders or rubber boots
❏
Cooler with plenty of ice and soda
❏
Folding table
❏
Lawn chairs
❏
First-aid kit
❏
EZ-up or canopy for shelter
BOW: The front of the boat.
STERN: The back of the boat.
PORT: This is the left side of the boat when aboard and facing
the front (bow).
STARBOARD: This is the right side of the boat when aboard
and facing the front (bow).
HULL: The body of the boat.
DECK: The top of the boat.
RUDDER: The hinged vertical plate mounted at the stern that
controls steering.
SPONSON: The projections at either side of hull that give
lateral stability on the water.
Carefully remove your U-18 Miss Vegas Hydroplane from the
box and place it atop the pre-built boat stand. Remove all
remaining components from the box. You may wish to keep
the box in order to more easily transport and store your
U-18 Miss Vegas Hydroplane.
Decals have been provided for your U-18 Miss Vegas
Hydroplane. Simply cut them out, peel, and stick! See the
photos on the box for recommended decal placement.
TRANSMITTER ASSEMBLY
❏
1. Remove the transmitter antenna from the parts bag and
screw it into the top of the transmitter. To ensure that the
antenna is attached, lightly pull on the base of the antenna. If
it slides out, it is not installed properly.
FINAL ASSEMBLY
BOAT TERMINOLOGY
OTHER USEFUL ITEMS TO HAVE ON HAND
ITEMS REQUIRED FOR COMPLETION &
OTHER USEFUL TOOLBOX ITEMS
3